Guillou RP, Frank JD, Sinnott MT, Meyer EG, Haut RC, Déjardin LM. AJVR 2008 69 1419 Objective-To compare the bending properties of pantarsal arthrodesis constructs involving either a commercially available medial arthrodesis plate (MAP1) or a specially designed second-generation plate (MAP2) implanted in cadaveric canine limbs and evaluate the effect of calcaneotibial screw (CTS) augmentation on the structural properties of both constructs. Sample Population-5 pairs of canine hind limbs. Procedures-Within pairs, specimens were stabilized with an MAP1 or MAP2 and loaded to 80% of body weight, with and without CTS augmentation. Compliance, angular deformation (AD), and plate strains were compared. Results-Construct compliance and AD did not differ between plates. Maximum plate strain was lower in the MAP2 than in the MAP1 (difference of approx 30%). Augmentation with a CTS reduced compliance, AD, and strains in MAP1 constructs but had no effect on those variables in MAP2 constructs. Conclusions and Clinical Relevance-Because of lower peak strains, the MAP2 may be less susceptible to failure than the MAP1. Furthermore, CTS augmentation was unnecessary with MAP2s, which could minimize intra- and postoperative morbidity. Compared with what is known for other dorsal plates, MAP2 constructs were associated with approximately 35% less AD. As a result of improved local stability, one might anticipate earlier fusion of the talocrural joint with an MAP2. In addition, plate peak strain was approximately 3.5 times lower in MAP2s than in dorsal plate constructs, which should result in greater fatigue resistance. The use of MAP2s may be a better alternative to both MAP1s and dorsal plates and could contribute to lower patient morbidity.